Do not identify a pipe thread from nominal size or outside diameter alone. BSP-family and NPT components can look similar and may begin to engage, but their profiles, pitches, taper conventions and gauges differ.
Names commonly encountered
| Marking or trade term | General meaning | Typical sealing principle |
|---|---|---|
| G or BSPP | Parallel pipe thread associated with ISO 228-1 | Pressure-tightness is normally made by a washer, O-ring, bonded seal or face, not by the parallel thread alone |
| R or BSPT male | Taper external thread associated with ISO 7-1 | Pressure-tight joint made on the threads with the specified sealing practice |
| Rc or BSPT female | Taper internal thread associated with ISO 7-1 | Pressure-tight joint made on the threads |
| Rp | Parallel internal thread intended for an ISO 7-1 pressure-tight threaded joint with a taper external thread | Joint design follows the applicable standard and product instructions |
| NPT | American taper pipe thread covered by ASME B1.20.1 | Pressure-tightness is made on the taper thread using the specified jointing method |
Identification workflow
- Find cast, moulded or printed markings and the manufacturer's model.
- Record male or female and where the component was made or sourced.
- Check whether the thread appears parallel or tapered.
- Measure major diameter and pitch with suitable tools, without rounding.
- Compare both measurements with the correct standard table or a verified gauge.
- Confirm the intended sealing surface and specified sealant.
- Reject any damaged, burred or cross-threaded component.
Why “one inch” is not a measurement
Pipe-thread sizes are nominal. The measured major diameter is larger than the nominal label, and closely named BSP and NPT sizes can have very similar diameters. Pitch and thread form are therefore essential evidence.
Parallel and taper are not installation instructions
A parallel thread may be a mechanical attachment that seals on a washer or O-ring. Applying more tape cannot correct a missing face seal. A taper thread relies on controlled engagement and the approved jointing method. Excessive tightening can split plastic female fittings.
Compatibility boundary
Do not rely on the fact that mismatched parts turn together. Do not use thread sealant as an adaptor. Use a purpose-made, pressure-rated transition whose two ends are explicitly stated, and verify material, potable-water suitability, operating pressure and surge.
Related guidance
Sources and limitations
See ISO 7-1, confirmed current by ISO in 2026, ISO 228-1 for threads where the pressure-tight joint is not made on the thread, and ASME B1.20.1 for NPT-family threads. Full dimensional confirmation requires the relevant standard, gauges and manufacturer data.
Live BSP-labelled examples
These current products show different stated BSP connection arrangements. Use the detailed product record only after the existing component has been positively identified.

PVC Adaptor Union Plain/BSP (Female/Male O-Ring)
Representative live variant: 50 mm × 1½-inch. Confirm both the plain pipe family and threaded sealing arrangement. SKU example: PFABRI050F.

316 Stainless Steel 90° Male × Female BSP Elbow
Representative live variant: 1-inch. The product states male × female BSP; confirm duty and sealing method. SKU example: SS09206.

Stainless Steel Elbow 90° BSP
Representative live variant: 1-inch. The product states female × female BSP; check exact fit before assembly. SKU example: SS09006.
Selection boundary: None of these cards proves that BSP, BSPT, NPT, a parallel seal or an unknown thread will mate. The PVC union includes its own O-ring arrangement; the stainless elbows have different male/female geometry. Choose the metal fittings or PVC collection only after the standard and sealing face are known.