Head-to-head spacing places each sprinkler approximately within reach of its neighbours so overlapping patterns can compensate for the weak edge of a single pattern.
Radius and spacing: a 6 metre example
If a sprinkler has an actual operating radius of 6 metres, a rough head-to-head starting layout puts neighbouring sprinkler centres about 6 metres apart, not 12 metres. Each sprinkler must throw approximately to the neighbouring head. The 12 metre figure is the diameter of one wetted circle; placing heads 12 metres apart merely makes those circles touch at their edges and does not give head-to-head overlap. Confirm the final spacing with the exact manufacturer data, operating pressure, wind and site conditions.

Why overlap matters
A catalogue radius describes throw under stated test conditions, not even watering across the whole circle. Begin with the manufacturer’s spacing guidance, then allow for wind, pressure variation, boundaries and obstacles. Do not stretch positions merely to reduce sprinkler count.
Lay out from boundaries
Place perimeter and corner sprinklers first, keeping water inside the intended area. Fill the interior only after the edges work. Check every sprinkler against adjacent positions in both directions and avoid relying on one head to throw around a tree or building.
Verify in the field
Run the completed zone at design flow, measure operating pressure and perform a catch-can test. Adjusting radius does not automatically correct poor spacing or an unsuitable nozzle pattern.
Related Irri Hub guides
Checks for your site
Use this general guidance alongside the selected manufacturer’s current data and a site-specific design. Measure running pressure, available flow and levels, and assess water quality, soil, planting and local requirements. Do not mix figures from different product families. Electrical work and contaminated or non-potable water require the appropriate competent assessment.
Browse by brand Rain Bird · Hunter · Netafim
Technical sources
- FAO Pressurised Irrigation Techniques: system design
- Rain Bird Landscape Irrigation Design Manual
- Hunter Residential Sprinkler System Design Handbook
- Netafim pressure-compensating emitter technical data
Compare rotor examples
Compare these catalogue examples against the required flow, pressure, connections and spacing using current manufacturer data before ordering.

Hunter I-25-06
Catalogue example: 6-inch plastic-riser rotor with check valve and 1-inch BSP connection. SKU HUNSPR-I2506PC-CV.

Hunter I20
Catalogue example: Hunter I20 rotor. SKU HUNSPR-I2004PC-SS-CV. Confirm the exact model and nozzle data against the required spacing.