Start here if a pipe, thread, sprinkler inlet or fitting is unknown. Do not order from colour, a remembered trade name or a rough diameter alone. Record the service, material, markings, dimensions, pressure and joint type first.
Choose the right route
| What you are looking at | Use this guide |
|---|---|
| Sprinkler body, swing joint or riser connection | Sprinkler inlet sizes and connections |
| Broad, coarse thread on a sports or golf assembly | ACME threads in irrigation |
| Thread marked BSP, BSPT, G, R, Rc or NPT | BSP, BSPT and NPT identification |
| Nozzle, sprinkler body or performance-table question | Sprinkler body and nozzle compatibility |
| Pipe size does not match the ruler measurement | Nominal and actual pipe sizes |
| PE, MDPE or HDPE wording | PE, MDPE and HDPE explained |
| Blue pipe with a barrier layer or brown stripes | Barrier pipe explained |
| Grey, brown, black or orange waste-type pipe | Soil, drainage and ducting pipe compared |
| Old metal pipe | Lead, copper and galvanised pipe |
| Rigid plastic pipe that may be PVC | PVC pressure pipe versus soil and drainage pipe |
Minimum identification record
- Photograph the complete item and every printed, moulded or cast marking.
- Record where it starts and ends, what it carries and whether it is pressurised.
- Isolate safely and consider stored pressure or automatic pump starts.
- Measure outside diameter in millimetres with callipers where practical.
- For a thread, record male or female, parallel or tapered appearance, pitch and sealing arrangement.
- For pipe, record material, outside diameter, wall thickness or SDR, pressure class and standard.
- Check the exact manufacturer document for the model or pipe range.
Three different selections
Fitting size is usually controlled by the connection geometry. Hydraulic size is controlled by actual internal diameter. Suitability is controlled by pressure, temperature, water quality, environment, approvals and the complete joint system. One measurement cannot answer all three.
Safe boundary
Do not force threads, machine an adaptor on site, solvent-weld an unverified plastic, use drainage fittings on pressure pipe or connect an irrigation system to wholesome water without the required backflow protection. Unknown potable-water or contaminated-ground pipework needs competent assessment and, where applicable, the water undertaker's agreement.
Existing Irri Hub guides
- Which irrigation pipe do I need?
- Metric or imperial PVC?
- MDPE pipe colours and identification
- PE and MDPE SDR and pressure ratings
- Identify and label irrigation pipework
- Practical irrigation pipe sizing
Sources and limitations
See Water Regs UK selection guidance and pipe-identification guidance. This gateway helps gather evidence; it cannot certify an unidentified component or replace the selected manufacturer's instructions.
Visual examples: record the connection, then select
The images below are labelled live products, useful for recognising the kinds of evidence to collect. They are not a visual match service.

Blue MDPE Water Pipe – Coil
Representative live variant: 25 mm × 50 m, PE80 SDR11. Confirm the selected diameter, SDR and service. SKU example: MDPEBL025050.

PVC Adaptor Plain × Threaded Male Metric
Representative live variant: 25/32 mm × 1-inch. Product information identifies its threaded end as BSP. SKU example: 80-23-23.

316 Stainless Steel 90° Male × Female BSP Elbow
Representative live variant: 1-inch. The product states male × female BSP; confirm duty and sealing method. SKU example: SS09206.
Selection boundary: A blue pipe, a plain-to-threaded adaptor or a BSP-labelled metal elbow does not establish compatibility with an unknown installation. Measure outside diameter and thread pitch, read markings, then compare the exact product record or use the pipework collection to locate the matching system.