A nozzle that physically fits is not automatically hydraulically compatible. The nozzle, sprinkler body, screen or stator, pressure regulator and performance table form a system.
Five compatibility checks
- Mechanical fit: exact body family, nozzle series, retention method and any screen or stator.
- Hydraulic duty: published flow and radius at the expected operating pressure.
- Pattern: arc, trajectory, strip or corner pattern and boundary behaviour.
- Application rate: compatibility with the other outlets on the zone.
- Control parts: pressure regulator, check valve, valve-in-head setting and any model-specific internal parts.
Do not select by colour alone
Nozzle colours and numbers are manufacturer and family specific. The same colour can mean something different in another range. Record the full marking and use the current performance chart for the exact sprinkler.
Replacement record
- Body make, model, pop-up height and inlet size.
- Nozzle family, number, colour, arc and trajectory.
- Screen, stator or adjustment component.
- Published test pressure and expected field pressure.
- Published flow in L/min or m³/h and radius in metres.
- Adjacent sprinkler type, nozzle and spacing.
- Reason for replacement and commissioning result.
Worked zone-flow check
If four selected nozzles are each published at 6.0 L/min at the intended pressure, their outlet total is 24.0 L/min. That arithmetic does not prove the zone will work. The designer must still check supply flow at pressure, pipe loss, elevation, valve and filter losses, operating pressure at each outlet, coverage and precipitation compatibility.
Mixed arcs and matched precipitation
A quarter-circle outlet covers less area than a full-circle outlet. Matched-precipitation families adjust flow with arc so that application depth can remain broadly compatible, but only under the manufacturer's stated conditions. Hand-throttling unrelated nozzles is not a reliable substitute.
Pressure and radius
Published radius is tied to test pressure and nozzle. Low pressure can shorten throw and harm rotation. Excess pressure can mist and distort the pattern. Use measured dynamic pressure while the zone runs, not static pressure at an idle source.
Commissioning
Flush the body as instructed, install the correct internal parts, set arc and radius, then observe rotation, trajectory, overspray and leakage. Verify the result with pressure and catch-can evidence where uniformity matters.
Related guidance
- Choosing sprinklers and nozzles
- Matched precipitation and mixed arcs
- Sprinkler operating pressure
- Catch-can and uniformity testing
Browse by brand Hunter
Sources and limitations
Current manufacturer performance tables control. The Hunter G-880 data illustrates model-specific nozzle, pressure, radius, flow and regulator combinations. It must not be applied to another sprinkler family.