A soil-moisture sensor reports conditions near its sensing volume. It does not automatically represent an entire zone.
Common measurement families
Volumetric-water-content sensors estimate the proportion of water in the soil volume. Matric-potential devices indicate how strongly water is held. The two measurements answer different questions and their numerical scales are not interchangeable.
Installation and placement
Install using the manufacturer method with good soil contact and minimal preferential gaps. Use representative depths and locations, including a control point where failure would matter. Keep sensors away from an emitter unless that is deliberately the monitored position.
Build site thresholds
Observe readings after thorough wetting and drainage, through normal drying and at visible plant response. Establish site-specific operating bands. Factory defaults or online “ideal percentages” should not override soil and plant evidence.
Related Irri Hub guides
Use this safely
This guide supports irrigation planning and observation. It does not replace a site-specific agronomic assessment, current product instructions, an abstraction licence, or professional advice where crop value, public safety or environmental risk is significant. Record whether figures are measured, estimated or taken from a published source.
Core sources
- FAO Irrigation and Drainage Paper 56: Crop evapotranspiration
- AHDB: Soil health and water supply
- RHS: Watering plants wisely
- Environment Agency: Manage water on land (England; check the regulator for the relevant UK nation)