Use this gateway to choose a route before selecting equipment. It separates basic selection, hydraulic design, installation, commissioning and fault finding so that a physical connection or attractive catalogue radius is not mistaken for a complete design.

1. Define the job
- Small lawns and borders: start with choosing sprinklers and nozzles and body and nozzle compatibility.
- Large turf, sports or agricultural areas: compare impact sprinklers, travelling irrigators and the additional controls required for large-radius sprinklers.
- Golf and managed turf: read valve-in-head sprinklers, quick-coupling valves and swing-joint selection.
- Drip and micro-irrigation: begin with dripline flow, filtration and pressure.
2. Prove the hydraulics
Measure available flow and dynamic pressure, identify the least-favoured outlet, then allow for elevation and losses through the supply, pipe, valves, filters, regulators and fittings. Use the selected manufacturer’s current flow and radius data at the intended operating pressure. Continue with zone-flow calculation, operating pressure and lateral pressure variation.
3. Design application, not only throw
Lay out head-to-head coverage where the selected method requires it, compare square and triangular arrangements, and keep application rates compatible. Use head-to-head spacing, layout geometry and matched precipitation. Wind, slope, soil intake and exclusion areas may control the practical result.
4. Install and commission
Confirm inlet size, thread, seal, support and finished level before assembly. For pop-ups, see installation height and finished grade. For low points, distinguish outlet drain-down from required backflow protection in check valves and low-head drainage. Flush, pressure-test and record the installed nozzle, arc, pressure and flow.
5. Test what the water actually does
Use a catch-can test for distribution evidence and follow dry-spot fault finding before increasing runtime. Drip systems should follow the drip commissioning checklist.
Detailed sprinkler and drip library
- Sprinkler design: worked zone example, slope and wind, and pop-up installation.
- Drip hydraulics: pressure-compensating versus non-compensating, emitter and row spacing, maximum lateral length and the zone-flow worked example.
- Drip installation: flushing, air and vacuum relief, subsurface drip, trees, shrubs and planters and filtration and blockage prevention.
Continue to suitable product families
Use the design route above first, then narrow the catalogue by application. The collection links below are starting points, not a substitute for checking flow, pressure, spacing, filtration and connection details.
See currently available landscape sprinklers · See drip pipe and fittings
Decision boundary
This gateway does not select a product or certify a site. Record whether each input is measured, estimated or taken from current data. Large moving machines, high-energy jets, public areas, non-potable water, chemicals and work near electrical lines require site-specific risk assessment and competent control.