A useful irrigation audit separates water use, leakage, hydraulic performance, application uniformity and plant outcome. One figure cannot diagnose all five. Start with evidence, correct clear defects, then test under representative operating conditions.
Audit sequence
- Define the boundary: list sources, meters, storage, pumps, zones, areas, planting, operating windows and any abstraction or discharge conditions.
- Establish a baseline: use the meter-reading and water-use method for daily, weekly and zone records.
- Check unintended flow: carry out a controlled night-flow or isolation test, then localise abnormal movement with safe isolations.
- Correct obvious defects: repair broken outlets, stuck valves, damaged pipe, overspray and unsafe equipment before judging distribution.
- Test application: for sprinklers, use the catch-can and distribution-uniformity test. For drip systems, compare representative emitter discharge and pressure.
- Review scheduling: compare applied depth with soil, root-zone, weather and plant evidence using the soil and scheduling gateway.
- Prioritise actions: address safety and major leakage first, then control faults, pressure problems, distribution defects and scheduling.
Worked gross-depth check
A weekly meter total of 42 m³ applied to 2,800 m² represents 42,000 ÷ 2,800 = 15 mm gross depth. If an independently justified application-efficiency assumption were 75%, the illustrative net depth would be 15 × 0.75 = 11.25 mm. Application efficiency is not the same as distribution uniformity, and neither figure proves that the root zone received the intended water.
Evidence to retain
- Meter identifiers, units, pulse factors, start and finish readings.
- Zone areas, run times, nozzles or emitters, pressures and measured flows.
- Catch-can or emitter results, wind and test conditions.
- Soil observations, root depth, rainfall, weather data and plant response.
- Defects, corrections, retest results, costs, savings assumptions and owner.
Do not create false savings
Reducing run time without correcting poor coverage can exchange water waste for dry areas. Do not increase all run times merely to compensate for a low-quarter result. Correct pressure, spacing, nozzles, leaks and scheduling causes first, then verify the outcome.
Scope and compliance boundary
This page is a practical audit route, not a statutory water audit or a guarantee of savings. Metering and reporting conditions may apply to an abstraction licence. Requirements differ across the UK, so confirm the relevant regulator, water undertaker and site permissions.