Start here when the question is how much water to apply, how often to irrigate, or how soil and roots change the answer. This gateway separates observation, calculation, controller settings and seasonal maintenance so you can reach the right level of detail without treating every article as an equal first step.
Choose the question first
- Water runs off or ponds: start with soil infiltration, then use cycle and soak.
- You need a watering depth or interval: combine available water capacity, effective root-zone depth and soil-water balance scheduling.
- You have weather or ET data: read evapotranspiration explained, then reference ET and crop coefficients.
- You have a soil sensor: start with soil-moisture sensors or tensiometers, then commission the control logic rather than accepting a default threshold.
- You are preparing for cold weather: use seasonal shutdown and restart, the compressed-air safety guide and spring recommissioning checklist.
- You want to reduce waste: follow the water-efficiency audit route.
Understand the soil store
Soil texture and structure influence infiltration, drainage and water storage, but a texture name is not a complete design value. Field capacity and wilting point define useful concepts, while soil-moisture deficit provides an operating record. Stones, layering, compaction, salinity, organic matter and actual rooting can change the result.
Match the schedule to the planting
Use scheduling for turf, borders and trees for established areas and watering new plants and turf during establishment. Rain-gauge totals are not automatically effective rainfall, so record canopy interception, runoff, drainage and the measured wetting depth where the decision matters.
Turn evidence into controller settings
Estimate effective rainfall, use sensor-based scheduling where suitable, and apply seasonal adjustment only after the base programme is sound. Keep the scheduling review record so changes can be checked against plant condition, soil response and measured water use.
Worked route
The worked scheduling example shows how assumptions are carried through a daily balance. It is a learning check, not a universal watering prescription.
Evidence and limitations
Metric units are used first. A water depth of 1 mm over 1 m² equals 1 litre. Published soil and crop values are starting estimates unless the page states otherwise. Important designs require representative site observations, current weather data, plant requirements, manufacturer information and any applicable abstraction or use restrictions.
Core sources
- FAO Irrigation and Drainage Paper 56
- AHDB soil health and water supply guidance
- RHS watering guidance
- Environment Agency guidance on managing water on land for England; check the regulator for the relevant UK nation.