Start here for irrigation hydraulics, measurements, pump-system behaviour and the evidence behind Irri Hub calculations. This gateway keeps the practical route visible while detailed equations, worked examples and source registers remain available when they are needed.
Choose the question you need to answer
- Measure an existing supply: use flow and pressure measurement, understand static, dynamic and residual pressure, and record measurement uncertainty.
- Check a pipe or zone: start with flow, area and velocity, then use Reynolds number, Darcy-Weisbach friction and the Colebrook-White friction factor.
- Understand pressure along a route: use Bernoulli’s equation, hydraulic and energy grade lines, component losses and the critical-path check.
- Assess a pump system: use total dynamic head, pump and system curves and suction, cavitation and NPSH.
- Investigate shocks, air or unreliable readings: use water hammer and pressure surge, air valves and pressure gauges and test points.
Engineering foundation
The calculation route uses continuity, Bernoulli, Darcy-Weisbach, Reynolds number and Colebrook-White as connected methods. The hydraulic foundation worked example shows how those stages interact. Controlled interpolation explains when a value may be estimated between verified tabulated points.
Inputs and evidence
- Engineering inputs, units and evidence
- Water properties and validity
- Pipe roughness evidence
- Irrigation Science Centre
- Irri Hub Research Centre
- Technical source register
- Testing and review status
- Irrigation glossary
How to use a result
- Record whether each input was measured, assumed, calculated or taken from manufacturer data.
- Keep units explicit and preserve enough digits during intermediate steps.
- Check the result against a second method, known case or field measurement where practical.
- State limitations, safety boundaries and the decision the result supports.
- Use current manufacturer limits and competent site-specific design where failure could cause injury, flooding, contamination or material loss.
Product boundary: this library explains methods and evidence. It does not by itself confirm that a particular product or SKU is suitable. Check the exact catalogue item against the measured site requirements and current manufacturer information before ordering.
Sources and status
Principal references were checked on 16 September 2026, including the US Bureau of Reclamation Water Measurement Manual, USDA NRCS Irrigation Pipeline Standard 430, NIST Technical Note 1297, USACE pressurised-pipe-flow reference and HSE pressure-systems guidance. Educational checks are not construction approval or a replacement for current standards, manufacturer data and competent engineering.