How to Calculate Irrigation Zone Flow

Zone flow is the sum of all outlets operating together under their design conditions.

Sprinkler zone

Zone flow = sum of individual nozzle flows

Use the manufacturer flow at the intended nozzle and operating pressure. If ten identical outlets each use 6.2 L/min, the zone flow is 62 L/min. Where nozzles differ, list every outlet rather than multiplying an average.

Dripline zone

Zone flow = total active length ÷ emitter spacing × emitter flow

For 300 m of dripline with emitters every 0.33 m at 2.0 L/h, the nominal number of emitters is approximately 909 and nominal zone flow is about 1,818 L/h, or 30.3 L/min. Use the manufacturer’s permitted run length, pressure and rounding method.

Add only simultaneous demands

Do not add every outlet on the site if the controller operates zones separately. Do add master-valve, bypass, wash-water or other simultaneous flows where they genuinely occur.

Check pressure dependence

Non-pressure-compensating outlet flow changes with pressure. Use the expected pressure range, not a single catalogue point, and confirm that the zone remains within the equipment limits.

Allow for flushing separately

Dripline flushing can require a flow different from normal irrigation. Document whether laterals flush together or in groups and verify the source can maintain the required flushing velocity.

Related guides

Sources and limitations

This guide supports planning and record keeping. The final design must follow current manufacturer instructions, site risk assessments, legal duties, water-undertaker requirements and applicable standards. Relevant references include HSE HSG47, Water Regs UK backflow guidance and BS EN 805:2025.