Use this guide to choose irrigation pipe by purpose, outside diameter, pressure rating, connection system and whether it carries potable water.
Common routes
- Black irrigation polyethylene pipe: widely used for irrigation mains, laterals and outdoor water distribution with matching metric fittings.
- Blue MDPE: commonly associated with below-ground potable-water services and must use suitable approved fittings and installation practice.
- LDPE micro pipe: used for small irrigation take-offs and emitters, not as a substitute for a main supply pipe.
- PVC pressure pipe: a rigid solvent-weld system using its own compatible fittings and pressure classes.
Measure before ordering
Read the printing on the pipe where possible and measure the outside diameter. Do not assume that an old pipe follows the nearest modern metric size. Check the fitting system as well as the nominal description.
Size for flow, not convenience
Undersized pipe increases friction loss and can leave sprinklers or dripline short of pressure. Establish the required flow, length, elevation change and acceptable pressure loss before selecting a diameter.
For an existing installation, send photographs of the pipe markings, an outside-diameter measurement and the fittings already used.
Outside diameter, bore and nominal size are different
Most compression fittings are selected from the pipe outside diameter. Hydraulic calculations depend on the actual internal diameter, which changes with wall thickness and pressure class. A nominal description alone is therefore insufficient for both fitting selection and accurate pressure-loss work.
Build a pipe schedule
- Service: mainline, zone lateral, drip header, suction line or potable-water route.
- Material and exact outside diameter.
- Pressure class or standard designation printed on the pipe.
- Actual bore where a hydraulic calculation needs it.
- Length, elevation change, fittings and design flow.
- Jointing system, adaptors and any transition to an older installation.
Check velocity and pressure loss together
A larger pipe usually reduces friction loss, but the final choice must also consider working pressure, surge, water temperature, installation method, joint system and cost. Use the Darcy-Weisbach method for transparent friction calculations and state the bore and roughness evidence used.
Existing and buried pipework
Do not identify buried pipe only by colour. Trace the service where possible, read markings, measure exposed outside diameter and confirm whether the water is potable. Follow the relevant manufacturer, water-undertaker and installation requirements for depth, bedding, warning tape, pressure testing and disinfection where applicable.
Pipe identification guide
Compare pipe types
These are live examples from the current catalogue, arranged by their stated product information rather than by colour alone.

Black & Green Stripe Poly Irrigation Pipe – Coil
Example variant: 25 mm × 100 m. Check the selected outside diameter and coil length. SKU example: 02053-259575.

Blue MDPE Water Pipe – Coil
Example variant: 25 mm × 50 m, PE80 SDR11. Confirm the selected diameter, SDR and service. SKU example: MDPEBL025050.

Black Poly Irrigation Pipe – Coil
Example variant: 25 mm × 100 m, PE100 SDR11. Check the exact variant before design or fitting selection. SKU example: HPPEBK02510016B.
Before choosing: The green-stripe, blue-MDPE and black-PE examples are not substitutes. Confirm the exact material, outside diameter, SDR or pressure designation, service and manufacturer instructions. Browse the poly pipe collection, compression fittings and PVC collection only after recording the existing system.