Cycle-and-soak divides a required runtime into shorter applications separated by rest periods.
When it helps
Use it where the sprinkler application rate exceeds short-term soil intake, on slopes, compacted turf or where runoff begins before the target depth is applied. It does not repair poor coverage, blocked nozzles or an unsuitable design.
Set it from observation
Run a representative zone and record the time to first ponding or runoff. Choose a cycle shorter than that time, then provide enough soak time for water to move into the profile. Recheck as soil moisture and surface condition change.
Keep the total visible
Four five-minute cycles still equal twenty minutes. Verify the total depth with catch measurements or known precipitation rate, and confirm the controller does not accidentally repeat programme start times.
Related Irri Hub guides
Use this safely
This guide supports irrigation planning and observation. It does not replace a site-specific agronomic assessment, current product instructions, an abstraction licence, or professional advice where crop value, public safety or environmental risk is significant. Record whether figures are measured, estimated or taken from a published source.
Core sources
- FAO Irrigation and Drainage Paper 56: Crop evapotranspiration
- AHDB: Soil health and water supply
- RHS: Watering plants wisely
- Environment Agency: Manage water on land (England; check the regulator for the relevant UK nation)