Sprinkler Spacing and Precipitation Rate

Technical guidance: Use current nozzle performance tables for the selected sprinkler and pressure.

Overlapping sprinklers operating around a golf green
Overlapping sprinkler coverage around a golf green.

Radius and spacing: a 6 metre example

If a sprinkler has an actual operating radius of 6 metres, a rough head-to-head starting layout puts neighbouring sprinkler centres about 6 metres apart, not 12 metres. Each sprinkler must throw approximately to the neighbouring head. The 12 metre figure is the diameter of one wetted circle; placing heads 12 metres apart merely makes those circles touch at their edges and does not give head-to-head overlap. Confirm the final spacing with the exact manufacturer data, operating pressure, wind and site conditions.

A sprinkler’s radius is not a promise of even coverage. Irrigation layouts depend on overlapping patterns, correct pressure, suitable nozzles and spacing that reflects wind and site geometry.

Head-to-head spacing

Head-to-head spacing means one sprinkler throws approximately to the neighbouring sprinkler. This overlap compensates for the fact that a single sprinkler does not normally apply water evenly from its centre to the edge. Square and triangular layouts have different geometry and must not be mixed casually.

Pressure controls the pattern

Low pressure can shorten throw and produce weak distribution. Excessive pressure can create misting and drift. Check operating pressure at the sprinkler while the zone is flowing, not static pressure at the supply.

Precipitation rate

Precipitation rate is the average water depth applied per unit time, commonly mm/h. For a rectangular area:

Application rate (mm/h) = total flow (m³/h) × 1000 ÷ area (m²)

Because 1 litre spread over 1 m² is 1 mm, the same relationship can be formed from litres per hour divided by square metres.

Worked example

Four sprinklers apply a combined 2.4 m³/h over a representative 200 m² area:

2.4 × 1000 ÷ 200 = 12 mm/h

A theoretical 30-minute run would apply about 6 mm on average. Actual scheduling must account for distribution uniformity, soil intake, slope, weather and plant requirement.

Matched precipitation

Nozzles covering different arcs should apply similar depth over their respective areas when operated together. A quarter-circle nozzle does not necessarily need the same flow as a full-circle nozzle. Use a matched nozzle family or calculate each contribution from controlled data.

Wind and site shape

Wind distorts patterns and may require closer spacing than calm-condition radius data suggests. Avoid relying on one sprinkler to reach around obstacles. Use part-circle control and perimeter placement to limit overspray onto buildings, roads and paths.

Field verification

A catch-can test measures actual distribution. Place identical containers across a representative area, run the zone under stable conditions, measure captured depths and assess average application and uniformity. Repeat after nozzle, pressure or spacing changes.

Related Irri Hub pages

Browse by brand Rain Bird

Sources and limitations

See Rain Bird’s Sprinkler Spacing and Design guidance and Landscape Irrigation Design Manual. Manufacturer radius and flow tables are test-condition data, not guaranteed field uniformity.