Every irrigation measurement has uncertainty. Flow, pressure, level, pipe diameter, elevation and time are affected by instrument limits, installation, reading technique and changing system conditions. Uncertainty is not the same as a mistake; it describes how well the result is known.
Build an evidence trail
- identify the instrument, range, resolution and stated accuracy;
- record calibration or comparison status where relevant;
- state operating conditions, units, location and time;
- repeat readings when conditions can be held reasonably stable;
- separate measured values from assumed, derived and manufacturer values.
Worked flow check
Three timed-container tests collect 18.9, 19.3 and 19.1 litres in 30 seconds. The mean collected volume is:
(18.9 + 19.3 + 19.1) ÷ 3 = 19.1 L
The corresponding mean flow is 19.1 ÷ 30 × 60 = 38.2 L/min. The observed range is 0.4 L per 30 seconds, equivalent to 0.8 L/min. Reporting 38.20000 L/min would imply precision the test does not support. A useful record is “38.2 L/min mean from three 30-second tests; readings 37.8, 38.6 and 38.2 L/min”, plus container and timing limitations.
This range is not a formal expanded uncertainty. A formal budget may need Type A statistical evaluation, Type B instrument information, corrections and a stated coverage factor.
Use significant figures sensibly
Keep extra digits during intermediate calculations, then round the final result to match the least certain controlling input. Do not round so early that the answer shifts materially. Always retain units and do not mix bar, kilopascals, metres head, litres per minute and cubic metres per hour without showing the conversion.
Decision boundary
A measurement can be fit for checking a garden zone but insufficient for pump acceptance, pressure testing, abstraction compliance or a contractual performance test. Define the decision first, then choose the method and evidence quality.
Related Irri Hub routes
- Engineering inputs, units and evidence
- Controlled linear interpolation
- Pressure gauges and test points
- Testing and review status
Sources and limitations
Sources checked 16 September 2026: NIST Technical Note 1297 and the US Bureau of Reclamation Water Measurement Manual. This page provides a practical introduction, not an accredited calibration or formal uncertainty procedure.