Metric and imperial PVC pressure systems are different size families. Similar-looking parts may not fit or seal correctly.
How to identify the system
- Look for printed size and pressure markings on the pipe.
- Measure the pipe outside diameter accurately.
- Check whether the fitting is a socket, threaded or adaptor connection.
- Compare the measurement with the manufacturer's dimensional table.
Do not identify PVC from a rough ruler measurement or the thread description alone. An imperial nominal bore is not the same as its measured outside diameter.
Joining and repair
Use compatible pressure-rated pipe, fittings, cleaner and solvent cement, following the manufacturer's preparation and curing instructions. Where systems must transition between standards, use a purpose-made adaptor rather than forcing mismatched components together.
Isolate and depressurise the system before cutting or dismantling it. If you cannot match the markings and measurements to a size table, send us clear photographs and the measurements before ordering.
Use the printed marking, outside-diameter measurement and manufacturer's dimensional table together. Colour, a socket measurement or a description such as “one inch” is not enough on its own.
Do not mix size systems accidentally
Metric pressure pipe is normally identified by an outside diameter in millimetres. Imperial pressure pipe uses a nominal size whose actual outside diameter is different from that nominal number. Threads form another size system and do not identify the adjacent socket or pipe standard.
Before buying a repair fitting
- Clean enough pipe to read every visible marking.
- Measure an undamaged straight section with callipers where possible.
- Record the outside diameter in millimetres without rounding to a convenient size.
- Confirm the pressure class and whether the pipe carries potable water.
- Photograph the complete fitting and any moulded markings.
- Use a listed transition fitting if two systems genuinely need joining.
Solvent-weld safety
Use the pipe and fitting manufacturer's approved preparation, cleaner and cement system. Joint strength depends on fit, surface preparation, temperature, assembly and cure time. Ventilate the work area, follow the safety data, and do not fill or pressure-test the installation before the stated cure period.
Product and SKU references
Use exact product links and SKUs when comparing pipe and fittings. Check the size system, outside diameter, pressure class, material, jointing method and current manufacturer limits before ordering. A generic description such as “one inch PVC” does not confirm compatibility.