Irrigation Service Visit and Inspection Report

A service report should distinguish observation, measurement, work completed and recommendation. It should let another person understand the system state before and after the visit without treating every note as proof of a diagnosis.

Visit identity and scope

  • Site, date, weather, technician, client contact and arrival/departure time.
  • Requested task, assets or zones included and areas explicitly excluded.
  • Drawings, previous reports, manuals and permits available.
  • System state on arrival, including active alarms, isolations and controller mode.

Condition and measured evidence

Record source level, meter reading, static and dynamic pressure, representative zone flow, pump behaviour, filter condition or differential pressure, valve response, outlet condition, controller settings, sensor response and visible leakage. State instruments, units, resolution and test conditions.

Worked flow check

If a verified meter advances by 0.48 m³ during an eight-minute zone test, the average flow is 480 ÷ 8 = 60 L/min, equal to 3.6 m³/h. Compare it with a commissioned value only when the zone configuration, pressure and measurement boundary are equivalent.

Work completed and settings changed

List components cleaned, adjusted or replaced; software or programme changes; isolations restored; flushing performed; and tests repeated. Record exact component identity only from reliable evidence. Do not create a product recommendation or SKU when the catalogue relationship has not been verified.

Defects and priorities

Separate immediate safety issues, active leakage or failure, developing condition, efficiency opportunity and advisory improvement. Give each action an owner and target date. Photograph location and asset reference where this improves traceability.

Open field box and cover among grass and fallen leaves
Open field box and cover among grass and fallen leaves.

Close-out

Confirm operational state at departure, automatic programmes enabled or disabled, outstanding isolations, customer explanation, waste removed and records updated. A signature can acknowledge receipt; it does not automatically prove technical acceptance or waive an unresolved defect.

Safety and limitations

Do not energise, pressurise, excavate or dismantle solely to complete a form. Electrical, pressure, chemical, confined-space and machinery work require suitable competence, isolation and safe systems. A service report is not statutory certification unless completed under the relevant scheme and requirements.

Related guides and sources

Return to design and delivery