A valve that fits the pipe is not necessarily compatible with the controller or duty. Record the hydraulic, electrical and connection requirements before selecting a replacement.
Identify the existing valve
- Manufacturer, body marking, model and flow arrow.
- Connection type, nominal size and thread family. Do not assume a measured outside diameter identifies BSP, BSPT or NPT.
- Solenoid voltage, AC or DC type, latching/non-latching operation and stated inrush/holding demand.
- Permitted operating pressure and flow range, including any minimum differential pressure.
- Water-temperature, water-quality and filtration limits.
- Manual bleed, flow-control stem and pressure-regulation features.
Selection sequence
- Confirm the controller output and the exact solenoid load it can operate, including simultaneous master-valve or pump-relay demand.
- Check the valve pressure rating against maximum static and transient pressure, not only normal running pressure.
- Check the manufacturer's loss data at the design flow. A nominally correct valve can consume too much pressure.
- Confirm body material, seals and water-quality suitability.
- Match end connections with pressure-rated fittings; never force unlike pipe threads together.
Normally closed does not mean fail-safe
Most landscape irrigation valves are normally closed, opening when their solenoid is energised. Debris, torn diaphragms, incorrect assembly, low differential pressure or a stuck manual bleed can prevent reliable closure. A master valve and flow monitoring may reduce consequences, but neither removes the need for isolation and commissioning.
Commissioning record
Record the zone served, design and measured flow in L/min, upstream and downstream pressure in bar, solenoid resistance only where the manufacturer provides a valid test range, controller station, valve-box location, filter condition and leak/closure test.
Safety boundary: isolate pressure before dismantling. Never infer electrical compatibility from wire colour. Potable-water interfaces require the correct backflow protection. Use the valve fault guide for symptom-led checks and the manifold guide for access and layout.
Limitation: this is a specification checklist, not a product recommendation. Use the current datasheet for the exact valve and controller.
Current valve examples
These examples illustrate different electrical and hydraulic choices. They are not interchangeable. Confirm the controller output, valve size, connection, pressure range and manufacturer data for the exact product before selection.
Hunter PGV 1-inch 24 V AC valve
A 1-inch female BSP valve for a compatible 24 V AC controller. SKU: PGV-101-G-B.
Rain Bird 100-DVF 9 V DC valve
A latching-coil example for a compatible battery controller. SKU: B70350.1. Do not substitute it for a 24 V AC valve.
Hunter ICV commercial valves
A multi-size product selector for commercial duties. The verified 1-inch variant is SKU HUNVAL-ICV025-; check the selector for the other exact sizes.
Continue from guidance to equipment
- See currently available solenoid valves
- See currently available landscape solenoid valves
- See currently available pre-assembled valve arrangements